Power factor correction capacitors are typically wired in parallel with the motor load at various points in the distribution system. In situations where a variety of inductive motors or loads are being switched on and off independently, it is desirable to apply the capacitance to the individual load. For that reason, it is important that power factor correction be specifically matched to the inductive load with which it is associated.
In an ideal system, a motor is corrected when its inductive reactance equals the capacitive reactance at the line frequency … over or under correction of the load will result in poor performance and possible damage to the capacitors and motors. Over correction occurs when the resonance frequency is less than the line frequency.

Each inductive load—especially electric motors—requires a properly sized power factor correction capacitor. While a helpful starting point may be found in standard look-up tables or other theoretical predictors of optimum capacitance, the better practice is to specifically match the capacitance to the measured characteristics of the particular motor design.

IPFusion integrated power factor correction units include a housing (which supports at least one capacitor), control and power terminal blocks, precharge controls, all interconnecting wires, and a contactor for selective engagement of the capacitor into the load circuitry. The capacitor and contactor are electrically connected to the load, and are engaged during the initial phase of load activation.

APFusion automatic power factor correction units are suitable for use where harmonic generating loads are less than 15% of the total connection load.

The Benshaw Promise

Only Benshaw has a three year guarantee.
Benshaw Power Factor Correction units are guaranteed for three full years. Other manufacturers limit their warranties to just one year. But at Benshaw, we believe that … because we build our products better … we can guarantee them longer. We call that "The Benshaw Promise."